HELIBORNE HomeCatalogueInfoContactsPycckuú
HOMEINFORMATION
     
 

SCALE RESIN SETS


Our resin sets are suitable for modellers aged 14 years and older.
Part placement on the sprue is subject to change without notice.
The shade of grey resin may vary from shown at the photos.

• Remove thin parts from sprue using a sharp craft knife; scratch a few times along the join between the part and sprue. Thick sprues can be removed using a hacksaw. Mount the sprue in a vise and remove part. Use Silicone Carbide sandpaper or Tungsten Carbide files to clean contact surfaces. Usual sandpapers and fine files can also be used, but will be less effective.
• Use CA glue (cyanoacrylate, "super-glue") for assembly. Gel-type CA glues are more effective for most joints.
• Parts can be painted with water-based (acrylic) or spirit-based (enamel, etc.) paint. An undercoat of primer is required.

The sets contain small parts with some sharp edges. Keep parts out of the reach of children! Parts contain polyurethane resin. Avoid contact with eyes and mouth. Always wear goggles and dust mask when working with resin parts. Use a wet cloth to clean up your workplace and wash hands with soap after use.

 
     
AVIATION TOP 100 - www.avitop.com Avitop.com 2014-2015, HELIBORNE. All rights reserved.